|Home » |
Sheet Metal Nibbler Cutter
Capacity: Mild steel plated up to 1.8mm, stainless steel plated up to 1.0mm
Copper, aluminum or plastic up to 2.0mm
Characteristics: Excellent cutting speed by 2 meter per minute with 3000RPM
Best cutting result without any burrs at the cutting edges, 360? changeable direction at operation
To be fitted with any electric drill or power drill with 3000RPM
|Average Customer Rating:
|| based on 3 reviews|
Average Customer Review:
( 3 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
5 of 5 found the following review helpful:
Did the job perfectNov 05, 2012
Worked perfect for the job which was to cut up a steel drum for scrap. I was amazed that it worked so well on the heavy gauge sheet metal. Works way better than a saw. Highly recommended if you just need to do the occasional cutting job. If you do regular sheet metal cutting then go for a higher-end product.
1 of 1 found the following review helpful:
It did a fantastic job. The metal in this area is not ...Jul 03, 2014
By Steven Donnell
This is a but kicking tool, I used it to cut a hole in the trunk of my wife's car to change out the EVAP canister. It did a fantastic job. The metal in this area is not very thick, about as thick as a fender panel. Only complaint I have is when I ordered it, I tried to get a spare cutting bit, it is not offered. For thin metal and the price, you can't beat it.
Threw it is the garbage, junkOct 07, 2014
By Hans Baij
Worked very well for a very short period of time. It cut about 8 feet of 18 ga metal and the bit broke. Threw it is the garbage, junk!!!!!